Morning all. Hope someone out there can give me a few pointers on using the clone a Willy kit. The wife and i tried to use the kit the other night with disasterous results. Namely the molding gel set to quickly (or we were to slow). What my question is. I was thinking of cutting the bottom of the tube off and laying down with my penis inside the tube and having the wife pouring the molding gel into the tube. Has anyone tried it this way and if so what were the results. I have ordered 2 more bags of the mold powder (just to be on the safe side). Many thanks.
Hi there. My partner and I purchased one of these kits a while back and were able to successfully (more or less) use it first time. We did it by following the instructions with a little adjustment. Firstly, I sat down for the moulding. My partner did almost all the prep and I adjusted the tube length as required. I think the key with this is prep. We also laid a sheet down on the floor as there was quite alot of leakage. Another key tip - trim your pubes. Doesn't matter how long you keep them - shave them off. The gel is really sticky and cutting the mould free with scissors can be quite daunting. Another tip - maybe hold your penis at the base and then hold the gel filled tube at an appropriate angle - initially we had issues with parts of my penis being pressed against the tube which would have resulted in less than accurate moulding.
As for the method you are describing - I think that could work well. The key thing there is laying your penis inside the tube may lead to the above mentioned moulding issue.
Reading that back - not sure I've helped much - but hopefully there's some info there you can use on ure further attempts.
Nope but I've been keen to try one for the laugh... sold out at the moment so I'll have to wait.
Thankyou toylover. Yes done all the prep work. Measured .shaved (got the rash to prove it. Lol. Got the water at right temp then mixed powder for 60 seconds as instructions but it started to set before we could get it in the tube. As i said I've ordered 2 bags of the powder so will try instructed method first but only mix for 45 seconds. If that does not work will try the laying down pouring in method. Will post results. Again thanks for input.
I have also been looking into buying one of these for ages but never quite convince myself to... I am sure though that there are better instructions/suggestions in one of the many reviews for the kit.
*There are better instructions in the reviews - arrange the reviews by 'Most Helpful' and you'll find the ones i'm on about...