Why do i struggle to put a cock and ball ring on cant seem to get balls in
Are you using lube? It really helps. :)
Try one of these, without a doubt the best cock ring I've ever used...
Good shout with the lube as well Lollipop, always lube up..
Lube is essential for me, can be quite painful without!
I open it up with my hands inside in and cup my mans balls then slide the ring off my hand I couldn't know how else to do it
my hubby uses this http://www.lovehoney.co.uk/product.cfm?p=28652
pulls the toggle bit all the way to the end (leave a little bit of the ring poking out or you will never get it back on if the toggle comes off) and a little bit of lube. Puts penis through and stretches over balls and then tightens.
Is it a metal ring? If so I find best way is plenty of lube, put cock in first, then pull through loose sack, and then gently squeeze balls through one at a time. Sorry if to much info.
Metal cock rings or any kind of fixed ring should be put on when flaccid. Put testicles in then push willy through
There's a technique which I have learned from the ancient Japanese art of cockerami.
What you do is pop your old chap and his two baggy friends into the end of an (old) stocking, think much like genitals robbing a bank.
then you pop your balls through the ring and the penis - still in the stocking.
As advised above, please complete this task when in a non-aroused state.
Once you're happy with the position, then act like a magician and whip that stocking off leaving everything else where it was.
by jingo one enringed old chap.
then lube up if it feels tight, or keep the stocking on for a different sensation.
It's a bit of an art, make sure you're nice and warm, say after a bath and everything is more baggy, yes lube is good but I've found with it your fingers are TOO slippery to help, so without any at the start I do this
Place to one side a bit and gently push one ball through leaving the other still to the upper other side, give the loose skin of the one through the ring a bit of a pull, to make, as much skin through the ring as you can, now tease/push the other ball through give the whole lot a tug, gently.
Now stick some lube on your bit and push/coax/pull it through holding the ring at the same time, once you've done that grab a hold of everything just in front of the ring then push the ring back with your other hand as far as it will go. It seems much easier with my metal rings than the "sticky" silicone one, don't give up just take practice, if you think it will be a bit of a mood killer, all that messing around, put it on a hour or so before, I wear my metal one for days with no harm.